The pc communicates with the arduino via the serial port.
Arduino pwm fan controller.
The temperature and fan speed are reported through a 8 digit 7 segment display fitted on a rack mounted aluminium bar.
The ultimate project is to control the fan based on temperature.
The frequency values can be adjusted between 125 hz 8 mhz as well as a variable duty cycle.
On the pcb there is a 5 12v input for the fan supply.
Getting temperature values from a digital or analog temperature sensor on an arduino is fairly simple.
4 wired fan control pwm control a pwm fan with arduino.
There is a jumper for switching the power supply from arduino or the 12v input.
The system works by an application running on the pc checking the cpu temperature and checking whether to speed up or slow down the fans.
For this reason i used arduinos d6 pin pwm.
It then becomes a matter of telling the fan pwm to raise or lower the speed based on the temperature.
It is efficient because the pass transistor is used as a switch.
Design schematic diagram is shown next.
Pwm waves with various duty cycle are shown in the figure below.
I have been wondering about this project and how to control my 4 pin pwm fans.
In the above wave forms you can see that the frequency is same but on time and off time are different two applications of pwm control using arduino is shown here.
The pwm controller accepts the control signal and adjusts the duty cycle of the pwm signal according to the requirements.
So after that no electricity flows through it turning the fan off.
The blue led seen on the prototype board is just for verifying correct circuit.
An inexpensive single small pass transistor like 2n222 or bd139 can be used here.
The arduino throttles the fans using pid logic and drives them through pwm.
Many projects that use a temp sensor but never the most simple thing.
Control the speed of the fan.
There is some information out there.
Beginner full instructions provided 24 154.
Firstly make sure that you fan s are pwm controller you can check this by making sure that your fan connector has 4 wires.
I o pin 9 on the arduino board is directly connected to fan control input and by reading the state of 3 push buttons on pins 2 3 4 different pwm values are sent to the fan.
A low frequency pulse width modulation pwm signal whose duty cycle is varied to adjust the fan s speed is used.
The system uses a temperature sensor to control four fans that are driven by an arduino controller.
Pwm fan controller sketch can be downloaded here.
I had 5 laying around and thought mine as well give it a shot.
Temperature based fan speed control monitoring with arduino.
